Tag: instrumentation
-
Cable Screens: Types & Connections
Electromagnetic Compatibility (EMC) is one of the key factors of consideration in the design, construction, manufacture and installation of electrical and electronic equipment and systems. Electrical equipment must be designed not only to meet a functional technical performance specification but due consideration must also be given to the interaction the equipment has with the electromagnetic…
-
Instrumentation Systems Installation: Precautions to Take
Analog systems are normally based on low voltages and as a result, they are vulnerable to electrical noise. In most plants, a PLC may be controlling 415 V high power motors at 100 A, and at the same time, reading thermocouple signals of a few mA. Great care must therefore be taken to avoid interference…
-
Basic Facts about 4-20 mA current loop in Process Instrumentation
The 4-20 mA current loop, like the one shown in the diagram below is a typical way of transmitting sensor information in most of industrial process monitoring applications. A sensor in this case is a device used to measure the physical parameters such as liquid flow rates, temperature, pressure, speed, and so on. The 4-20…
-
Digital Voltmeters: Basic Features, Operation & Applications
The digital voltmeter (DVM) displays measurement of ac or dc voltages as discrete numbers instead of a pointer deflection on a continuous scale as in analog instruments. A digital voltmeter basically consists of an analog-to-digital converter, a set of seven-segment numerical displays and the necessary BCD-to-seven-segment drivers. A digital voltmeter is a versatile and accurate…
-
Fault Protection & Diagnostics in Power ICs using Temperature Sensors
Fault conditions sensing for example, the detection of a short circuit is an integral part of many smart power integrated circuits (ICs)/power ICs. The ability to get temperature sensors in the semiconductor process provides protection and diagnostics as part of the features of these devices. The main function of the power IC is to provide…
-
Digital Multimeter: Principle of Operation and How it is used
A Multimeter or volt-ohm-milliammeter (VOM) is an instrument used to measure current, voltage, and resistance. It can be used for measuring dc as well as ac voltages and currents. The two common types of multimeters include the analog multimeter and the digital multimeter. Analog multimeters employs a moving pointer mechanism that swings a long a…
-
Single-Ended vs. Differential Amplifiers
Most often than not, the signal from the sensor in a measurement and control or monitoring system is very small (one millivolt or less) and a key step in signal conditioning is amplification. Therefore, the sensor is often connected to the input terminals of an amplifier. The amplifier in this case can either be single-ended…
-
Causes of Ground Loops in Instrumentation & How to Avoid Them
Causes of Ground Loops In Instrumentation We may have situations in instrumentation and control systems, where the sensor and the signal conditioning unit such as an amplifier or current-to-voltage converter are located some distance apart and are connected by a cable. This can lead to several problems that can reduce the accuracy or in extreme…
-
Telemetry in Instrumentation Systems
Telemetry can be defined as the science of gathering information at some remote location and transmitting the data to a convenient location to be examined and recorded. Importance of Telemetry Within instrumentation there is usually a requirement for telemetry in order to transmit data or information between two geographical locations. The transmission may be needed…
-
How Capacitive Probes are Used to Measure Level
Capacitive probes can be used to measure the depth of liquids and solids. A rod, normally coated with PVC or PTFE, is inserted into the tank and the capacitance measured to the tank wall. The capacitance has two components C1 above the surface and C2 below the surface. As the level rises C1 will decrease…