The resistance of an electrical conductor depends on 4 factors, namely:
The resistance, R, is directly proportional to length L of a conductor.
Resistance, R, is inversely proportional to cross-sectional area a, of a conductor.
Because R is proportional to L and, R is proportional to

By inserting a constant of proportionality into this relationship, we can take care of the material used. This constant of proportional is known as the resistivity of the material and represented by the symbol ρ.
Hence,
Therefore, ρ is measured in ohm meters (𝝮m). The value of the resistivity is the resistance of a unit cube of the material measured between opposite faces of the cube.
Recommended:
Resistivity varies with temperature. Good conductors of electricity have low value of resistivity and good insulators have a high value of resistivity.
Generally, as the temperature of a material increase, most conductors increase in resistance, insulators decrease in resistance, while the resistance of some special alloys remains almost constant.
The temperature coefficient of resistance can be defined as the increase in the resistance of a 1 𝝮 resistor of that material when it is subjected to a rise of temperature of 1 °C. The symbol for temperature coefficient is α. For example if say a copper wire of resistance 1 𝝮 is heated through 1 °C and its resistance is then measured as 1.0043 then α = 0.0043 𝝮/𝝮°C for copper. The units are normally expressed as per °C
Don’t miss out on key updates, join our newsletter List
So, α = 0.0043/°C
If the 1 𝝮 resistor of copper is heated through 10 °C then the resistance at 10 °C will be 1 + 10×0.0043 = 1.043 𝝮.
If the resistance of a material at 0 °C is known, then the resistance at any other temperature can be determined from:
Rϴ = R0(1 + α0ϴ)
Where, R0 = resistance at 0°C
Rϴ = resistance at temperature ϴ °C
α0 = temperature coefficient of resistance at 0°C
You can also read: Inductance
Image source: Pexels Smart homes are no longer futuristic. They are already here, changing how…
Thyristors are semiconductor devices that tend to stay ‘ON’ once turned ON, and tend to…
Image source: Freepik Introduction: The Evolution of Connectivity Telecommunications have come a long way since…
Modern manufacturing demands smarter heat treatment. Specifically, factories seek greater precision, energy efficiency, and automation.…
An Expert’s Guide to EV Load Management and NEC Compliance Smart EV charging control architectures…
Frequent power failures due to severe storms, aging grid infrastructure, and other unpredictable natural disasters…